Mobile Crossing WayPoint Map Loader Manuale dell'Operatore Scaricare il pdf (Pagina 58)

Once the MAP parameters have been specified, push OK MAKE MAP and the MAP will be stored in a MAP file along

with the borders and associated COASTLINE and FEATURES file names. Even if you do not intend to use Loran

lines, they are created in case they may be needed.

Unless Loran features have been hidden, the window will display the program's choice of Loran line spacing and the

number of Loran TD lines that will appear on the MAP for each station of the chain pair. If you do not like the spacing

the program selected, you can change it. You can enter line spacing from 0.1 to more than 1000 microseconds as long as

this doesn't cause the number of lines printed on the MAP to exceed 35 for either TD. If you are not going to use Loran

lines, this selection is of no consequence.

Note: A possibly easier way to create a MAP is by using: Chart Operations >Make A Map From This Chart.

This MAP will be the size of the area that was displayed but scaled to fit the page. If you adjust the borders, it will

recalculate the right border longitude.

4.2 View Map

This command will allow you to display a MAP on the screen along with the waypoints from the open file to verify that

it is correct before printing it. The display shows that the MAP has boundaries and a Loran grid scaled for the MAP.

You can pan and zoom this display, but the MAP will always print just what is shown inside the borders.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 129 130

Nessun commento

Mobile Crossing WayPoint Map Loader Manuale dell'Operatore Pagina 58